| View previous topic :: View next topic |
| Author |
Message |
blue89 Member

Joined: 23 May 2006 Posts: 3482 Location: Bellingham/Eugene
1986 Chevrolet Camaro RS
|
Posted: Wed May 06, 2009 8:59 am Post subject: 28 spline 10 bolt axles |
|
|
I'm trying to upgrade. I have a spare 10 bolt drum housing, a 28 spline auburn limited slip, and 3.42's. Only problem is that I don't have the axles! Can anyone help me out? The first drift event is May 17th and I'm trying to make it there AND drive it down there. My current axle is too high for highway use so I need to swap them. Either that or try to put this thing on a trailer. Any leads would be great, I'd drive as far as seattle for a decent set of 28 spline 10 bolt axles. _________________ E30
86 RS - 7.4L V8 SOLD
89 RS - 3.25L V6 REMOVED
89 RS - 5.7L LT1 SOLD
|
|
| Back to top |
|
 |
blue89 Member

Joined: 23 May 2006 Posts: 3482 Location: Bellingham/Eugene
1986 Chevrolet Camaro RS
|
Posted: Fri May 08, 2009 8:33 am Post subject: |
|
|
| Nothing? I'll take the whole rear end if someone has one. |
|
| Back to top |
|
 |
rjmcgee The Hammer

Joined: 08 Jan 2004 Posts: 2328
|
Posted: Fri May 08, 2009 1:07 pm Post subject: |
|
|
| When I did this a few years ago I could't find any used. Moser wasn't all that expensive, that's the route I finally went. |
|
| Back to top |
|
 |
Red Bird Member
Joined: 28 Jun 2005 Posts: 195 Location: Yakima
1991 Pontiac Firebird
|
Posted: Sat May 09, 2009 7:20 pm Post subject: |
|
|
id hit up the boneyards try to find a 90+ v6 or v8 car or good ol craigslist _________________ 1991 Firebird L03 T-5 |
|
| Back to top |
|
 |
|