| View previous topic :: View next topic |
| Author |
Message |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Sat Aug 12, 2006 2:43 pm Post subject: Parting 1985 Camaro Z/28 |
|
|
As the post says.
Here's what I'm keeping:
Alternator
Power Steering pump
Distributor
Transmission
Clutch and pressure plate
Flywheel
Bellhousing
Everything else is up for grabs.
This will only stick around until September 2nd then it will be junked. _________________

Last edited by Quasi-Traction on Sun Aug 13, 2006 11:18 am; edited 1 time in total |
|
| Back to top |
|
 |
Xophertony Rodeo Queen

Joined: 13 Oct 2005 Posts: 5306 Location: Portland, Oregon.
1988 Pontiac GTA
|
Posted: Sat Aug 12, 2006 6:54 pm Post subject: |
|
|
| i'll take the firebird steering wheel. unless you are going to throw it on the berli. |
|
| Back to top |
|
 |
rjmcgee The Hammer

Joined: 08 Jan 2004 Posts: 2328
|
Posted: Sat Aug 12, 2006 9:51 pm Post subject: |
|
|
| How much for the pedals, hydraulics, and bell housing? |
|
| Back to top |
|
 |
Twilightoptics Hardcore (12sec Club)

Joined: 13 Jan 2004 Posts: 9191 Location: Auburn , WA
1987 Chevrolet Camaro IROC-Z
|
Posted: Sat Aug 12, 2006 11:02 pm Post subject: |
|
|
| rjmcgee wrote: | | How much for the pedals, hydraulics, and bell housing? |
How many 5speed thirdgens you need rod? |
|
| Back to top |
|
 |
turbo_jimi Member

Joined: 23 Feb 2004 Posts: 1206 Location: Tacoma
1985 Chevrolet Camaro Z/28
|
Posted: Sun Aug 13, 2006 1:59 am Post subject: |
|
|
What shape is the drivers side door and hood louvers in?
TJ _________________
1985 Z28 Crate 350, Hurst T-5, 3.23s, Flowmaster Under previous set-up: 143.82 rwhp 216.98 lbs. torque @4390 rpms 3/12/11 |
|
| Back to top |
|
 |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Sun Aug 13, 2006 11:15 am Post subject: |
|
|
| rjmcgee wrote: | | How much for the pedals, hydraulics, and bell housing? |
Sorry I didn't mention it earlier...bellhousing stays. The Berlinetta is getting the old T-5 out of the 85. $25 for the petals and hydraulics. I can get a shipping quote next week. Any prefered corurier? _________________
 |
|
| Back to top |
|
 |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Sun Aug 13, 2006 11:18 am Post subject: |
|
|
| turbo_jimi wrote: | What shape is the drivers side door and hood louvers in?
TJ |
no hood louvres. Its an 84 Z/28 hood with the flappers missing. Drivers side door is in pretty good shape about 99% straight. Probably will need to have the lock replaced. Its a Crank window that skips a couple teeth when the window is about 7/8 rolled up. _________________
 |
|
| Back to top |
|
 |
rjmcgee The Hammer

Joined: 08 Jan 2004 Posts: 2328
|
Posted: Sun Aug 13, 2006 1:47 pm Post subject: |
|
|
| Quasi-Traction wrote: | | rjmcgee wrote: | | How much for the pedals, hydraulics, and bell housing? |
Sorry I didn't mention it earlier...bellhousing stays. The Berlinetta is getting the old T-5 out of the 85. $25 for the petals and hydraulics. I can get a shipping quote next week. Any prefered corurier? |
What ever is cheap.
I'll pm you my adress |
|
| Back to top |
|
 |
Schultzy89GTA M.R.A. (11sec Club)

Joined: 08 Jan 2004 Posts: 4417 Location: Gresham, OR
1989 Pontiac GTA
|
Posted: Fri Aug 18, 2006 6:54 pm Post subject: |
|
|
Rod,
Targeted aquisition is complete.
Labor Day Delivery.
Thanks Chris.
-Schultzy _________________ Red Sled: 89 GTA, 383, TKO, N2O
12.73 @ 109.39, 1.793 60 \ 11.794 @ 121.16, 1.62 60 (old combo) |
|
| Back to top |
|
 |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Fri Aug 18, 2006 7:15 pm Post subject: |
|
|
No problem. Hope they serve rod well.. _________________
 |
|
| Back to top |
|
 |
Magman 11sec Club
Joined: 02 Apr 2005 Posts: 217 Location: Whidbey Island
1990 Chevrolet Camaro IROC-Z
|
Posted: Sun Aug 20, 2006 7:50 pm Post subject: |
|
|
85 Z's didn't come with the grid tail lights did they? I need some for my wifes 88 IROC.
Also looking for black: Rear speaker covers and the large panels under the dash, both sides. Drivers side covers the wiring and pass side covers the cpu.
Do you still have the wiring in the eng compt? I need a relay with the connector and 1' of the wires coming from the connector, I beleive it is the headlight relay, mine's melted. I'll PM you the info on the relay if available.
Magman _________________ 1990 IROC-Z, 383 HSR, 3.70 9-Bolt
383 RWHP / 372 TQ
11.78 @ 115 w/1.59 60' (8-18-2012) |
|
| Back to top |
|
 |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Sun Aug 20, 2006 10:14 pm Post subject: |
|
|
| IROC Magman wrote: | 85 Z's didn't come with the grid tail lights did they? I need some for my wifes 88 IROC.
Also looking for black: Rear speaker covers and the large panels under the dash, both sides. Drivers side covers the wiring and pass side covers the cpu.
Do you still have the wiring in the eng compt? I need a relay with the connector and 1' of the wires coming from the connector, I beleive it is the headlight relay, mine's melted. I'll PM you the info on the relay if available.
Magman |
85 was the first year of the Grids...mine don't have them however, The taillights off my old 84 Sport Coupe are on it because they were in better shape (and I like em better than the grids..)
I have the rear speaker covers in good shape, but they're grey...
Can you get a picture of the relay/headlight wiring that you're talking about? I'm sure I probably have it.
I have those covers for the underside of the dash to hide the wires, both passenger and driver side. $5 for the pair. _________________
 |
|
| Back to top |
|
 |
aaron_sK Member
Joined: 23 Jan 2006 Posts: 8834 Location: Back in beautiful Tacompton
1987 Chevrolet Camaro IROC-Z
|
Posted: Sun Aug 20, 2006 10:21 pm Post subject: |
|
|
| Rear speaker covers: do you have the little coathanger hook deals and screws for those too? If so, how much do you want for them? |
|
| Back to top |
|
 |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Sun Aug 20, 2006 10:21 pm Post subject: |
|
|
| Asdfga3 wrote: | | Rear speaker covers: do you have the little coathanger hook deals and screws for those too? If so, how much do you want for them? |
I'm about 99% certain I do. I'll look tomorrow. $1 for both of em. _________________
 |
|
| Back to top |
|
 |
aaron_sK Member
Joined: 23 Jan 2006 Posts: 8834 Location: Back in beautiful Tacompton
1987 Chevrolet Camaro IROC-Z
|
Posted: Sun Aug 20, 2006 10:23 pm Post subject: |
|
|
| I'd like the entire panels too, assuming Magman doesn't want them. |
|
| Back to top |
|
 |
Magman 11sec Club
Joined: 02 Apr 2005 Posts: 217 Location: Whidbey Island
1990 Chevrolet Camaro IROC-Z
|
Posted: Sun Aug 20, 2006 10:34 pm Post subject: |
|
|
Nope, the speaker covers are yours Asdfga3. I'll keep my eye out for some black ones.
I will however take the dash panels and the relay. I'll get a pic of it and post tomorrow. Thanks _________________ 1990 IROC-Z, 383 HSR, 3.70 9-Bolt
383 RWHP / 372 TQ
11.78 @ 115 w/1.59 60' (8-18-2012) |
|
| Back to top |
|
 |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Sun Aug 20, 2006 10:42 pm Post subject: |
|
|
Cool IROC-Magman.
I dunno if you're gonna be at the canada gathering, if you are, I"ll see if I can send em up with someone from here. If not I"m sure we can work shipping out.
Aaron,
I'll get those off tomorrow for you. since you want the whole pannel, we'll say $5 for the pair. Same deal, dunno if you'll be at the Canada thing, but if not, we'll work something out. _________________

Last edited by Quasi-Traction on Sun Aug 20, 2006 10:44 pm; edited 1 time in total |
|
| Back to top |
|
 |
aaron_sK Member
Joined: 23 Jan 2006 Posts: 8834 Location: Back in beautiful Tacompton
1987 Chevrolet Camaro IROC-Z
|
Posted: Sun Aug 20, 2006 10:43 pm Post subject: |
|
|
Cool. Thanks man.
Chris, how much for both covers, hooks, screws, ect. shipped to 98418? |
|
| Back to top |
|
 |
Quasi-Traction "I have petals"

Joined: 24 Oct 2005 Posts: 3873 Location: stumptown
1986 Chevrolet Camaro Berlinetta
|
Posted: Sun Aug 20, 2006 10:45 pm Post subject: |
|
|
couldn't give you an exact figure until I boxed em up and got the weight of the package. I wouldn't imagine more than about $3-5. _________________
 |
|
| Back to top |
|
 |
aaron_sK Member
Joined: 23 Jan 2006 Posts: 8834 Location: Back in beautiful Tacompton
1987 Chevrolet Camaro IROC-Z
|
Posted: Sun Aug 20, 2006 10:46 pm Post subject: |
|
|
| Cool. Tell me when you figure it out and I'll PayPal the cash. |
|
| Back to top |
|
 |
|