View previous topic :: View next topic |
Author |
Message |
aaron_sK Member
Joined: 23 Jan 2006 Posts: 8834 Location: Back in beautiful Tacompton
1987 Chevrolet Camaro IROC-Z
|
Posted: Thu Feb 09, 2012 5:03 pm Post subject: Yard Watch - Lakewood - Feb. 9th |
|
|
-Trans Am wrap-around spoiler with badly flaked paint but did not appear to be smashed.
-Decent looking glovebox lid in a white RS
Also looked to be a couple usable Camaro fenders (drilled for GFX), some t-tops, and a Firebird nose that was kinda beat up. |
|
Back to top |
|
|
jchaussee Member
Joined: 14 Nov 2010 Posts: 1318 Location: renton
|
Posted: Thu Feb 09, 2012 5:19 pm Post subject: |
|
|
T top bar? Good fuel tank?? |
|
Back to top |
|
|
aaron_sK Member
Joined: 23 Jan 2006 Posts: 8834 Location: Back in beautiful Tacompton
1987 Chevrolet Camaro IROC-Z
|
Posted: Thu Feb 09, 2012 6:25 pm Post subject: |
|
|
Did not check tanks but with three cars in the yard it's a good bet they have a good one out there.
One of the cars was a hardtop and one bar was trashed but there was a green RS I did not check the bar on. |
|
Back to top |
|
|
jchaussee Member
Joined: 14 Nov 2010 Posts: 1318 Location: renton
|
Posted: Thu Feb 09, 2012 6:27 pm Post subject: |
|
|
Were the rear ends removed from them? |
|
Back to top |
|
|
aaron_sK Member
Joined: 23 Jan 2006 Posts: 8834 Location: Back in beautiful Tacompton
1987 Chevrolet Camaro IROC-Z
|
Posted: Thu Feb 09, 2012 6:30 pm Post subject: |
|
|
Did not check axles as all of them were base models and sure to have poor gears. |
|
Back to top |
|
|
jchaussee Member
Joined: 14 Nov 2010 Posts: 1318 Location: renton
|
Posted: Thu Feb 09, 2012 6:43 pm Post subject: |
|
|
I was more curious about ease of removal of fuel tank |
|
Back to top |
|
|
turbo_jimi Member
Joined: 23 Feb 2004 Posts: 1206 Location: Tacoma
1985 Chevrolet Camaro Z/28
|
Posted: Thu Feb 09, 2012 7:23 pm Post subject: |
|
|
I might stop down there tomorrow. _________________
1985 Z28 Crate 350, Hurst T-5, 3.23s, Flowmaster Under previous set-up: 143.82 rwhp 216.98 lbs. torque @4390 rpms 3/12/11 |
|
Back to top |
|
|
|