Cascade Crew

jchaussee · Member Joined: 14 Nov 2010 Posts: 1318 Location: renton

Tri y long tubes from g and m honest performance. Anybody use them. 1 5/8 primaries , 14 gage metel. 3/8 flange. Pretty good price, but curious if anybody has used them.

DBL_TKE · Posted: Tue Nov 08, 2011 10:43 am Post subject:

You have a link? Never heard of them or seen them. Are they for 3rd gen's?

jchaussee · Member Joined: 14 Nov 2010 Posts: 1318 Location: renton

No link. They are at a performance shop in federal way. I dont know if they are in house or.locally made, but price is right, and yes they are for third gens

QwkTrip · Posted: Tue Nov 08, 2011 9:49 pm Post subject:

Tri-Y tend to be mid-length and can be excellent if done properly. Blends low speed response and torque with high speed flow and top end power. The headers I had custom made by Lemons for my big block were tri-Y. Also easier to package in car than 4-into-1.

DBL_TKE · Posted: Wed Nov 09, 2011 7:32 am Post subject:

I found a link to their site

http://honestperformance.com/

I am unable to view their catalog because I'm using an unjailbroke iPhone. How did you hear that the made headers for our F-bodies? I tried getting Dyno Don to make me a set of mid length, Tri-Y headers but he was reluctant to do so. Have you found out the pricing on these?

jchaussee · Member Joined: 14 Nov 2010 Posts: 1318 Location: renton

Yes, I have seen them installed. They seemed to fit fine. A little tight