| View previous topic :: View next topic |
| Author |
Message |
nonsensekid20 Member
Joined: 30 Sep 2010 Posts: 490
1991 Chevrolet Camaro RS
|
Posted: Sat May 28, 2011 3:39 pm Post subject: 5th gen seats in a 3rd gen? |
|
|
| Will this work? I saw the ZL1 seats. Kinda liked em. hahah |
|
| Back to top |
|
 |
IROCDave Member
Joined: 16 Jan 2010 Posts: 957 Location: Snohomish WA
1987 Chevrolet Camaro IROC-Z
|
Posted: Sat May 28, 2011 10:14 pm Post subject: |
|
|
| Welp, if GM is the same CO they were before the bailout they will bolt rite in. The seats should also be short enough to fit with 5th gens having that low roof. |
|
| Back to top |
|
 |
QwkTrip 11sec Club

Joined: 17 Feb 2004 Posts: 3942 Location: Peoria, IL
1989 Pontiac Firebird
|
Posted: Sun May 29, 2011 6:38 am Post subject: |
|
|
| I seriously doubt it. It's based on a 100% different chassis and floor board scheme. But adapter rails are not difficult for somebody with metal fab skills. |
|
| Back to top |
|
 |
Dewey316 The Lama

Joined: 08 Jan 2004 Posts: 7295 Location: Bringing the tech
1990 Chevrolet Camaro RS
|
Posted: Wed Jun 01, 2011 2:14 pm Post subject: |
|
|
If they don't fit, you need a bigger hammer.
Joking aside, if you are willing to put in some effort to adapt the right rails to the seats, you can make darn near anything fit. |
|
| Back to top |
|
 |
IROCDave Member
Joined: 16 Jan 2010 Posts: 957 Location: Snohomish WA
1987 Chevrolet Camaro IROC-Z
|
Posted: Wed Jun 01, 2011 4:44 pm Post subject: |
|
|
| The newer seats are alot taller than 3rd gen seats. I wanted to put some 04 - 06 GTO seats in my car but the top of the headrest would have only been a couple of inches away from the T-Top and they were to wide. |
|
| Back to top |
|
 |
|