Cascade Crew Forum Index Cascade Crew
Message Forums
 
 GarageGarage   1/4 Mile Table1/4 Mile Table   FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

awsome news
Goto page 1, 2  Next
 
Post new topic   Reply to topic    Cascade Crew Forum Index -> Back Porch
View previous topic :: View next topic  
Author Message
cameron7710
Member


Joined: 13 Apr 2008
Posts: 813
Location: shoreline,Wa

1992 Chevrolet Camaro RS

PostPosted: Wed Jun 10, 2009 6:00 pm    Post subject: awsome news Reply with quote

well i got a call from one of my friends today and turns out his neighbor has a jeep that he need to get rid of and said i could have it for free Very Happy Very Happy Very Happy
i talked to the guy and he said that its in great shape and everything the only problem is there is a small crack in the block in a water jacket so it leaks all the water out in 5-10 min but the engine itself runs great. so im gona go pick it up on Saturday and decide what to do with it. one thing tho since the crack isnt in the cylinder walls or anything would it be at all possible to take it to a shop and have them weld the crack up?

_________________


Last edited by cameron7710 on Wed Jun 10, 2009 6:21 pm; edited 1 time in total
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
chevymad
Master B


Joined: 11 Jan 2004
Posts: 5476


1987 Pontiac Formula

PostPosted: Wed Jun 10, 2009 6:07 pm    Post subject: Reply with quote

It all depends on where the crack is. Normally welding isnt the best way to fix one in a cast block though. Some people have ok luck, some dont. You could also "stitch" the crack if its accessible. You buy a type of plug, then drill, tap, insert plug.. then do the same thing over. Overlapping each plug. If its not accessible you could always try the "waterglass"/block seal method. Sometimes that works.
Back to top
View user's profile Send private message MSN Messenger
cameron7710
Member


Joined: 13 Apr 2008
Posts: 813
Location: shoreline,Wa

1992 Chevrolet Camaro RS

PostPosted: Wed Jun 10, 2009 6:24 pm    Post subject: Reply with quote

cool ill take a look at it when i get it.wont hurt to try everything other wises im gona use it to see how hard it would be to rip out a motor Very Happy
_________________
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
Twilightoptics
Hardcore (12sec Club)


Joined: 13 Jan 2004
Posts: 9191
Location: Auburn , WA

1987 Chevrolet Camaro IROC-Z

PostPosted: Wed Jun 10, 2009 8:05 pm    Post subject: Reply with quote

if it's a 4.0L you picked a hell of a motor to try ripping out first!

A crack that big usually means more problems. You're probably best to get a running motor off craigslist and drop it in.

_________________
A redline a day keeps the carbon away!
Back to top
View user's profile Send private message Send e-mail AIM Address MSN Messenger
cameron7710
Member


Joined: 13 Apr 2008
Posts: 813
Location: shoreline,Wa

1992 Chevrolet Camaro RS

PostPosted: Wed Jun 10, 2009 9:28 pm    Post subject: Reply with quote

Twilightoptics wrote:
if it's a 4.0L you picked a hell of a motor to try ripping out first!

A crack that big usually means more problems. You're probably best to get a running motor off craigslist and drop it in.
hmm that sucks now i just hope its not a 4.0L(with my luck it probly is) but ya i already got my eye on craigslist (even tho i cant afford anything Laughing or even know for sure what kind of engine im looking for:lol:)
_________________
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
GREG DAVIDSON
Member


Joined: 15 Mar 2008
Posts: 1159
Location: Salem

1989 Pontiac Formula

PostPosted: Fri Jun 12, 2009 7:01 pm    Post subject: Reply with quote

bout %90 of the jeeps have the 4.0 in them we've had no problems with the one my mom had and now coreys buying off her
Back to top
View user's profile Send private message Send e-mail Visit poster's website Yahoo Messenger MSN Messenger
cameron7710
Member


Joined: 13 Apr 2008
Posts: 813
Location: shoreline,Wa

1992 Chevrolet Camaro RS

PostPosted: Fri Jun 12, 2009 7:57 pm    Post subject: Reply with quote

GREG DAVIDSON wrote:
bout %90 of the jeeps have the 4.0 in them we've had no problems with the one my mom had and now coreys buying off her
ya it probly is o well ill just have to find out for sure tomarrow
_________________
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
corey davidson
Member


Joined: 12 Sep 2008
Posts: 351
Location: salem

1986 Chevrolet Camaro

PostPosted: Fri Jun 12, 2009 9:21 pm    Post subject: Reply with quote

if all else fails an du cant do any thing with i need a parts jeep mainly rims and tires and id buy it off u but if i were u check it out and if its the 4.0l high output go to any junk yard and should find the parts u need exspet down here were im to slow to get them Laughing for both of my cars
_________________
real men are covered in oil and grease
Back to top
View user's profile Send private message Send e-mail MSN Messenger
rjmcgee
The Hammer


Joined: 08 Jan 2004
Posts: 2328



PostPosted: Fri Jun 12, 2009 9:50 pm    Post subject: Reply with quote

corey davidson wrote:
if all else fails an du cant do any thing with i need a parts jeep mainly rims and tires and id buy it off u but if i were u check it out and if its the 4.0l high output go to any junk yard and should find the parts u need exspet down here were im to slow to get them Laughing for both of my cars



That's got to be a new f*ckin' record right there. Rolling Eyes
Back to top
View user's profile Send private message
DBL_TKE
Member


Joined: 28 Feb 2007
Posts: 1505
Location: Aloha, OR

1991 Chevrolet Camaro Z/28

PostPosted: Fri Jun 12, 2009 10:57 pm    Post subject: Reply with quote

rjmcgee wrote:
corey davidson wrote:
if all else fails an du cant do any thing with i need a parts jeep mainly rims and tires and id buy it off u but if i were u check it out and if its the 4.0l high output go to any junk yard and should find the parts u need exspet down here were im to slow to get them Laughing for both of my cars



That's got to be a new f*ckin' record right there. Rolling Eyes


Couldn't have said it better myself.

_________________
Richmond 3.73 posi| 36/24 sway bars | SLP LM2 | Koni's | Ground Control 800/200 | Y2K wheels | Dyno Don headers & Y-pipe | airfoil | BBK underdrive pulleys | Raised strut mounts | Extended ball joints | LCARB'S
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
cameron7710
Member


Joined: 13 Apr 2008
Posts: 813
Location: shoreline,Wa

1992 Chevrolet Camaro RS

PostPosted: Fri Jun 12, 2009 11:16 pm    Post subject: Reply with quote

Laughing will see i need to get it and figure out what to do i still might just sell it for parts but idno. but if i do i was told the tires have a good 35-40 thousand miles left on um
_________________
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
corey davidson
Member


Joined: 12 Sep 2008
Posts: 351
Location: salem

1986 Chevrolet Camaro

PostPosted: Sat Jun 13, 2009 1:19 am    Post subject: Reply with quote

f*ck i no i cant spell or write good you have to finish school to do that boys! so iv been told that my G.E.D. isnt schooling so f*ck! But ok yea keep me up dated and if u need any help if u do keep it i might be able to help
_________________
real men are covered in oil and grease
Back to top
View user's profile Send private message Send e-mail MSN Messenger
cameron7710
Member


Joined: 13 Apr 2008
Posts: 813
Location: shoreline,Wa

1992 Chevrolet Camaro RS

PostPosted: Sat Jun 13, 2009 9:29 am    Post subject: Reply with quote

ok will do, well i was just about to leave to pick it up and i get a call that he cant do it to day cause he need to find the title and get some tax things takin care of with it. so its lookin like i have to wait till around wendsday Sad
_________________
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address
QwkTrip
11sec Club


Joined: 17 Feb 2004
Posts: 3942
Location: Peoria, IL

1989 Pontiac Firebird

PostPosted: Sat Jun 13, 2009 11:02 am    Post subject: Reply with quote

cameron7710 wrote:
hmm that sucks now i just hope its not a 4.0L(with my luck it probly is)


4.0L is the best engine ever put in a Jeep. Hope it is a 4.0L straight six.
Back to top
View user's profile Send private message
Twilightoptics
Hardcore (12sec Club)


Joined: 13 Jan 2004
Posts: 9191
Location: Auburn , WA

1987 Chevrolet Camaro IROC-Z

PostPosted: Sat Jun 13, 2009 12:59 pm    Post subject: Reply with quote

QwkTrip wrote:
cameron7710 wrote:
hmm that sucks now i just hope its not a 4.0L(with my luck it probly is)


4.0L is the best engine ever put in a Jeep. Hope it is a 4.0L straight six.


I'm with stupid

_________________
A redline a day keeps the carbon away!
Back to top
View user's profile Send private message Send e-mail AIM Address MSN Messenger
Dewey316
The Lama


Joined: 08 Jan 2004
Posts: 7295
Location: Bringing the tech

1990 Chevrolet Camaro RS

PostPosted: Sat Jun 13, 2009 5:58 pm    Post subject: Reply with quote

4.0 is where it is at. Love mine.
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address Yahoo Messenger MSN Messenger
iansane
Member


Joined: 16 Jan 2004
Posts: 5742
Location: Bothell

1991 Pontiac Trans Am

PostPosted: Sat Jun 13, 2009 6:00 pm    Post subject: Reply with quote

QwkTrip wrote:
4.0L is the best engine ever put in a Jeep. Hope it is a 4.0L straight six.


I'd venture to say the LSx is the best engine ever put in a heep. Laughing
Back to top
View user's profile Send private message AIM Address
Dewey316
The Lama


Joined: 08 Jan 2004
Posts: 7295
Location: Bringing the tech

1990 Chevrolet Camaro RS

PostPosted: Sat Jun 13, 2009 6:01 pm    Post subject: Reply with quote

iansane wrote:
QwkTrip wrote:
4.0L is the best engine ever put in a Jeep. Hope it is a 4.0L straight six.


I'd venture to say the LSx is the best engine ever put in a heep. Laughing


I dunno, the Cummins diesel swaps are pretty bad arse.
Back to top
View user's profile Send private message Send e-mail Visit poster's website AIM Address Yahoo Messenger MSN Messenger
rjmcgee
The Hammer


Joined: 08 Jan 2004
Posts: 2328



PostPosted: Sat Jun 13, 2009 6:35 pm    Post subject: Reply with quote

Dewey316 wrote:
iansane wrote:
QwkTrip wrote:
4.0L is the best engine ever put in a Jeep. Hope it is a 4.0L straight six.


I'd venture to say the LSx is the best engine ever put in a heep. Laughing


I dunno, the Cummins diesel swaps are pretty bad arse.


But then you get stuck with a Heep and a rattle crap engine. Laughing
Back to top
View user's profile Send private message
iansane
Member


Joined: 16 Jan 2004
Posts: 5742
Location: Bothell

1991 Pontiac Trans Am

PostPosted: Sun Jun 14, 2009 9:18 am    Post subject: Reply with quote

Dewey316 wrote:
iansane wrote:
QwkTrip wrote:
4.0L is the best engine ever put in a Jeep. Hope it is a 4.0L straight six.


I'd venture to say the LSx is the best engine ever put in a heep. Laughing


I dunno, the Cummins diesel swaps are pretty bad arse.


I can't say I've seen that. Like a 4bt or something?
Back to top
View user's profile Send private message AIM Address
Display posts from previous:   
Post new topic   Reply to topic    Cascade Crew Forum Index -> Back Porch All times are GMT - 8 Hours
Goto page 1, 2  Next
Page 1 of 2

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group