Cascade Crew

I have a 1983 Pontiac Sales brochure, binder and a 1988 Firebird factory service manual available for free.

Selling my aluminum centerbolt valve covers. They need to be repolished but are in good condition. They've been sitting in my storage for a few years now.

PM if interested.

Ships and their electrical systems are already hardened against EMP.

They should change their motto to "Velocitas Ridiculum"

If the Air Force gets to have the F-22, the Navy gets to have railguns on every ship.

In another thread I saw mention of TGO and 'toothless retarded hicks" so that reminded me that I'm in Hermiston now! Hehe. It's not that bad, it's no Granite Falls, but I saw one guy in a giant S ...

Sorry, I was pretty cheap. Hopefully they didn't do anything that can't be undone. I don't trust myself with transmissions. I did do my rear axle which is doing good so far. Good luck!

I have the spohn torque arm and cross member as well. I don't have any issues with it hitting the floor, probably because my car sits pretty high. What is the pop coming from? I can hear mine do it oc ...

Sold

$Texas

I'll be much happier when this isn't my driver anymore so I can get some stuff done. The drivetrain is more or less pretty good but the car feels too cobbled together. I've had to add in wiring so it ...

Back when I had the 99 mustang I had the y-pipe break off where the passenger side manifold dumped into it.

When the defrost is on, the A/C compressor is used to dry the air. The water condensates ...

Thanks to Dewey for leading me to it. Who knows how long I would have overlooked the obvious.

Spark snapping at the coil.. plug wire in wrong place or not connected..

Bingo

One of the driver's side plug wires was off the dizzy from then I rerouted them to snake the TV cable underneath. ...

Well I got anxious and got some dielectric grease and put it on, and then I found an embarrassing mistake I made while putting the 700r4 in. The car runs much better. If I had the WB o2 in I'm sure th ...

I hope so. I need to have a new bung welded on as I am still using a single wire sensor and it's further downstream than I'd like. Tomorrow I'll mess with it. I found the aldl cable so I'll see what t ...

Got the sensor installed. I can't tell if it made any improvement because the threads came out with the old one. I had to unplug the WB sensor and move it there for now. Now the ignition coil is spark ...

It's currently super rich cold, and 15.5-16:1 lean warmed up. I haven't yet scanned it I have to find my aldl cable. The only indication I have is some hesitation on cruising and part throttle acceler ...

So I put most of a can of seafoam in the fuel and I'll run the last little bit down the intake tomorrow. I also got some MAF cleaner and I went ahead and bought an oxygen sensor since I don't know how ...

I've been battling an extreme rich cold start-up. Only happens when the car is first started after sitting for 8 or so more hours. Pegs my wideband at 10:1 and slowly climbs to about 13.5ish:1 until i ...

I think the more lope-ey the cam the higher RPM they are best for. And RPM and TPI aren't usually paired together.

All I have is headers, and a magnaflow cat-back, without a cat. I think it sounds more aggressive than my big block truck with headers and glasspacks. It might be that the truck is 8.0:1 and the lil 3 ...